Re: win xp to serial driver to qsr HELP!!

[ Follow Ups ] [ Post Followup ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by Narfman on January 31, 2007 at 14:09:34:

In Reply to: win xp to serial driver to qsr HELP!! posted by bill tomlinson on January 26, 2007 at 17:25:13:

Hi Bill,

Have you accessed the Global setup pages and configured the QSR for serial? See the manual. It needs to be set to 38.4 kbaud and the serial port on the PC should have the same speed setting. Also the PC needs to have the serial port setup as follows: 8 bit, 1 stop bit, no parity, and no handshaking to start with. The Roland serial driver has a setup tab where you can select Com1, 2, etc. and select handshaking mode if desired.

If you're still having problems e-mail me.


: just picked up a nice QSR. found a serial cable and downloaded the Roland driver listed at the site.
: installed driver, hooked up joy!
: any help from you pros would be appreciated beyound measure.

: using SoundTower "qs midi external error"

: ps. IBM 360x laptop 500 mhz.

: thanks
: bill

Follow Ups:

This is the old QS-Forum Archive
Please post messages on the new QuadraSynth Forum