Posted by Chris on July 12, 2000 at 13:41:17:
This is a solution to some questions in the archives:
Voyetra DOP, Cakewalk, and other sequencers send a pan position when a sequence starts whether you put pan changes in or not.
This sets some of the nice stereo programs to mono, which is bad for most of them, and disasterous for the pianos.
If you prefer to keep your program pan settings (they usually sound better) in a mix, use the sysex messages below. These sysex
messages reset the pans to the program settings.
Insert the sysex message into the sequence with your sequencer's event editor, so that the message is sent AFTER the sequence starts.
Do not auto send the sysex messages, or it won't work.
ch1- f0 00 00 0e 0e 10 21 00 02 07 f7
ch2- f0 00 00 0e 0e 10 21 00 0a 07 f7
ch3- f0 00 00 0e 0e 10 21 00 12 07 f7
ch4- f0 00 00 0e 0e 10 21 00 1a 07 f7
ch5- f0 00 00 0e 0e 10 21 00 22 07 f7
ch6- f0 00 00 0e 0e 10 21 00 2a 07 f7
ch7- f0 00 00 0e 0e 10 21 00 32 07 f7
ch8- f0 00 00 0e 0e 10 21 00 3a 07 f7
ch9- f0 00 00 0e 0e 10 21 00 42 07 f7
ch10-f0 00 00 0e 0e 10 21 00 4a 07 f7
ch11-f0 00 00 0e 0e 10 21 00 52 07 f7
ch12-f0 00 00 0e 0e 10 21 00 5a 07 f7
ch13-f0 00 00 0e 0e 10 21 00 62 07 f7
ch14-f0 00 00 0e 0e 10 21 00 6a 07 f7
ch15-f0 00 00 0e 0e 10 21 00 72 07 f7
ch16-f0 00 00 0e 0e 10 21 00 7a 07 f7
Note that these are for programs used in MIX mode only. - Chris