Posted by Drasch on July 09, 2000 at 10:24:58:
In Reply to: Can Micrologic access all my QS8.1 sounds? posted by minstrelle on July 07, 2000 at 12:51:28:
: I have successfully set up my QS8.1 with my PC and I
: am recording my sequences, but the library only lets me
: access 128 sounds on my QS. How can I access the rest
: of the mixes?
Hi,
You have to use the qs.dll module! You can open the dll from within
SoundDiver (File -> open). A list of all supported models in the library (QS6 - QS8, QS6.1 - QS8.1,...) is displayed. Select the right
one and use the scan button, to let SoundDiver check for the synth.
When it works correctly you should see all the four program and mix
banks!
I sometimes had problems whith the scan procedure, but after restarting
SoundDiver (somethimes i had to even reboot!) the synth was found
and it worked correct!
If you use SoundDiver you should check for patches of the oem-version
at www.emagic.de! (a lot of bugfixes, although the installer didn't
work always for me)
Hope this helps!
Regards,
Drasch
PS: I'm not quite sure if you should use File->open or open-library,
because I've no access to my home-PC to tell you exactly, but you'll
figure it out!