Re: Fading between 2 programs


[ Follow Ups ] [ Post Message ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by Andreas on July 07, 1999 at 14:07:45:

In Reply to: Fading between 2 programs posted by Michael on July 06, 1999 at 20:51:11:

I happen to have the same controller, pretty nice - but did you notice that it reaches maximum value about halfway through?
Anyways, fading between programs using the controller is done the same way as with the modulation wheel. If, for instance, you just want to modify a program to make the fade using the pedal instead of, say, Controller A, then enter program edit mode, search for occurances of Ctrl A and replace them by Pedal 1.
If you do an entire new program, you control the filter cutoff frequency of both programs. I.e. in the initial setting the cut off of program I is 99, i.e. everything is heard, and program II has a cutoff of 0, i.e. silence. Then you just tell the modulator to decrease, respectively increase the filter frequency for each sound.
I've to try that myself yet, too, but it should work that way.
Hope that helps,
Andreas



Follow Ups: