Re: QS6.1- using an amp

[ Follow Ups ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by Matt on August 12, 2002 at 12:28:36:

In Reply to: QS6.1- using an amp posted by Carl on August 11, 2002 at 10:25:28:


I face the same problem. I run the left 1/4 out to channel 1 and the right 1/4 inch out to channel 2. I then set the volume of one of the cannels a little higher than the other. Since any stereo effects (ie. Leslie speaker) are merely oscilating between the left and right channels you get a full sound from the amp even though it is not true stereo. Phasing is not a problem either. Good luck.



Follow Ups: