Posted by Darrel on March 04, 2002 at 13:24:10:
In Reply to: SRAm cards posted by Gary on March 04, 2002 at 07:57:33:
Gary;
It's in the manual under "Saving the User Bank to a PCMCIA Card".
Sram cards must be loaded from the User Bank. (Whatever is in the User Bank can be copied to the Sram card).
Put the Sram card in slot A.
Start by pressing "STORE", then page left three times. It will now read "Save User to CrdABnk 1 (STR).
Use the Value button to select a bank location on the card to store to (A1-8, etc.).
Each Bank on the Card has to be loaded in this fashion, in repeated steps as described above. OK? OK.
Scream if you have any problems (it helps).
Darrel