Re: Mod Wheel

[ Follow Ups ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by Ken Hal on January 22, 2001 at 03:37:44:

In Reply to: Re: Mod Wheel posted by Mike on January 10, 2001 at 07:38:25:


Thanks. Resetting the synth helped.

Resetting : switch off, make sure your mod wheel is all the way down, disconnect cables (?), press and hold Quad Knob 1 and 4, and switch on. Voila :D
Programs, Mixes nor effects will change.

: First, try resetting/rebooting the synth with the mod wheel completely in the down position when you do this. If the synth was reset with the mod wheel in some other position than down, it could be sending out erroneous midi data. The user manual will tell you how to reset the synth.

: If the data is comming from a software sequencer like Cakewalk, you can look in the event list and check for beginning mod wheel controller data events. You can either remove those events or change their value to 0.

: : Hi

: : When using any softsynths or midi sequencers on a pc, my mod wheel starts sending data when its 'halfway up' and not from the beginning in the 'down' position.
: : Is this a known problem ?

: : regards
: : Ken





Follow Ups: